Comfy HDL Design Setup

This is for those who want to get into coding in an HDL but don't know where to start, as I was a few months ago.

• The language: systemVerilog

• The simulator: Verilator

• The visualizer: GTKWave

How to code - simulate - visualize?

Code

First step is to write your design.

Simple example:

module blink ( 
    input clk,
    output led
    );

    assign led = clk;
    
    endmodule // blink

Then you write your testbench¹ to provide input to your DUT/UUT².

Simple example:

    module blink_tb;
        reg clk;
        wire led;

    blink dut (
        .clk(clk),
        .led(led)
        );
   
    initial clk = 0;
    always #5 clk <= ~clk;
  
    initial 
        begin
            $display("Running testbench...");
            $dumpfile("dump.vcd");
            $dumpvars(0);
            #30_000_000;
            $display("Done: made file dump.vcd");
            $finish;
        end
    endmodule // blink_tb

Simulate

If we keep the same design and testbench as above you can use a command such as this one to compile your tb: verilator --trace --binary --build-jobs 0 -Wall blink_tb.sv -Wno-lint -timing -o cool

After that, go into the obj_dir and the run the executable.

If you added a dumpfile in your code it should now be in the same directory.

Visualize

• Go into GTKWave.

• Make new tab with your .vcd file.

• Select all your signals in the left column.

• Analyze and enjoy!

Glossary

1. The function of a testbench is to apply stimulus (inputs) to the DUT/UUT, and report the outputs in a readable and user-friendly format.

2. Device Under Test | Unit Under Test.